1

Your cart is empty.

Firgelli Robots Hall-effect Switch Sensor (A3144)

Hall-Effect Switch Sensor (A3144)

$0.75

Hall-effect Switch Sensor (A3144)

Click to VIew Data Sheet

Description:

The A3144 is an integrated Hall effect non-latching sensor. Holding a magnet near the sensor will cause the output pin to toggle. This makes for a robust presence sensor. A reed sensor also works nicely, but can be limited by the glass encapsulation and size.

A hall effect sensor is much smaller, but can handle less current than a reed switch. The device includes an on-chip Hall voltage generator for magnetic sensing, a comparator that amplifies the Hall voltage, and a Schmitt trigger to provide switching hysteresis for noise rejection, and open-collector output. An internal bandgap regulator is used to provide temperature compensated supply voltage for internal circuits and allows a wide operating supply range.

If a magnetic flux density larger than threshold Bop, the output is turned on (low). The output state is held until a magnetic flux density reversal falls below Brp causing the output to be turned off (high) (see datasheet above by the link).

Features:

Superior Temp. Stability for Automotive or Industrial Applications
4.5 V to 24 V operation, works with most unregulated supplies
Open-Collector 25 mA output, compatible with digital logic
Reverse Battery Protection
Activate with Small, Commercially Available Permanent Magnets
Solid-State Reliability
Small Size
Resistant to Physical Stress

0.2 lb





Copyright © 2024, Firgelli Robots. Powered by Shopify.