Servo Switch Harness: Futaba/JR connector 30cm - 60 strands
With each AWG#22 cable conductor consisting of 60 strands, this wire harness can be used to add a toggle switch between any two devices that can be connected with JR/Futaba servo connectors. One side of the switch has a lead with a female connector, while the other side has one female connector.
A typical use for this harness in the RC hobby industry is to hook up a receiver battery to the male connector; the switch then controls whether current flows to the rest of the circuit through the female connector on the opposite side, while the female connector on the same side can be used to charge the battery without disconnecting it from the circuit.
Note: Female housing is installed with male pin header, while male housing is installed with female pin header.
* Length: 30 cm(end-to end)
* Rated voltage: 600V
* Rated temperature:-40°C~+105°C
* Conductor: Tinned copper
* Insulator: PVC
* OD Tolerance: ±0.10mm